Delta

LA803 4 wire three phase: 36" leads, 0-800 volts

Descripción

800 Series Specifications		LA 803
Type of design	Silicon Oxide Varistor^TM	Case Dimensions: 4-1/2" High 2-1/4" Diameter
Maximum current	100,000 amps
Maximum energy	3000 joules per pole
Maximum number of surges	Unlimited
Response time one milliamp test	5 nanoseconds
Response time to clamp 10,000 amps	10 nanoseconds
Response time to clamp 25,000 amps	25 nanoseconds
Leak current at double the rated voltage	None
Leads	36" #12 3kV Str
Case material	PVC
Locknut and Washer furnished	3/4" - 1 1/2"

LA 803 for 800 Volt, 3 Phase, 4 Wire Service LA 801 for 800 Volt, Single Phase, 2 Wire Service
Conduction Characteristics
Discharge Current	5000 A	10000 A	20000 A	40000 A	60000 A	80000 A	100000 A
Clamping Voltage (Line to Neutral)	500 V	1000 V	1100 V	1600 V	2400 V	4200 V	5500 V

INSTALLATION:
Fasten arrestor in place. Use a Delta mounting bracket, part # MB, a pipe strap, or a knockout hole. Connect the black wire to the hot line at any convenient point load-side of an existing fuse or circuit breaker. Connect the white wire to an existing ground system and the grounded metal framework of the equipment to be protected or make a ground source per NEC Article 250.

Electrical work is hazardous. Bad connections can result in fire, injury or death. Installation must only be done by qualified electricians.

In the event that a lightning discharge is so powerful that something has to be destroyed, the arrestor will take the damage. When sufficient heat and stress causes failure, a one-inch hole will open at the bottom of the enclosure. Hot silica and plastic bits will be expelled. Installing the arrestor in any approved electrical box will prevent accidental contact with a damaged unit.